Molex power midplate

Hardware
1

I have a Seasonic prime TX-1000

  • I assume it’s okay to use to power the midplate?
  • I have two cables in the box, one with two molex’s and one with 3 molex’s. I assume it’s okay if I use two molex connectors from each cable on the midplate?
1 Like
2

That will be fine. It’s not concise, but here’s a thread with some supporting info;

Basically, the only time someone might see an issue is if they were a) using a 4-molex cable into a single PSU SATA/PATA port or b) not using all four molex connectors on the midplate. So, spreading the load across the four molexes and two SATA connectors on the PSU, you’re fine.

1 Like
3

Hello… :wave:

As per my knowledge… Yes, the Seasonic Prime TX-1000 should have no problem powering the midplate, as it’s a high-quality PSU with plenty of capacity. Using two Molex connectors from each cable should be fine, but just make sure you’re not overloading any single cable or connector.

I hope this will help you!

Respected community member! :innocent:

1 Like